2752691 - 2127E50 hydraulic selection gearbox circuit pressure sensor - r r

Removing ( Refitting ) Remove the car from the ramps.Connect the Examiner and carry out the procedure to depressurise the gear actuation hydraulic circuit.To ensure depressurisation is successful, ensure:there are no errorsthe brake pedal is maintained depressed

Disconnect the electrical connection for the electric pump; the circuit will return to service pressure (45 bars) when the key is turned ON.

 - 5530B10  battery - r+r - 5530B56  BATTERY DRIP TRAY COVER - R.R. - 5530B52  Battery DRIP TRAY/SUPPORT - R.R.Position a suitable container to collect the coolant.1. Open the retaining band (1a) and disconnect the pipe (1b), radiator side.Move the pipe away from the work area. 1. Disconnect the electrical connection for the braking system control unit.

	Name	Connector
1	Braking system control unit	M51

1. Move the front wiring section away from the work area. 1. Disconnect the electrical connection (1a), and remove the pressure sensor (1b) from the gear actuation hydraulic unit.

	Name	Connector
1a	Pressure sensor on transmission	K96

Refitting ( Removing ) Fit the pressure sensor in its seating on the gear actuation hydraulic unit.Connect the electrical connection of the pressure sensor.

	Name	Connector
-	Pressure sensor on transmission	K96

Refit the front wiring section.Connect the electrical connection of the braking system control unit.

	Name	Connector
-	Braking system control unit	M51

Connect the pipe from the radiator to the engine, radiator side, and secure it with the retaining band. - 0010T21  coolant check density and top up if necessary - 0010T47  hydraulic system fluid for gearbox with hydraulic selection check level and top up if necessary - 0010T48  hydraulic system for gearbox with hydraulic selection bleed air - 5530B52  Battery DRIP TRAY/SUPPORT - R.R. - 5530B56  BATTERY DRIP TRAY COVER - R.R. - 5530B10  battery - r+rRemove the vehicle from the lift.