2753349 - 7210B70 R.R. REAR TRIM (structural element)
Removing
(
Refitting
)
- 7210B82 r r rear sacrificial
beamCheck if any of the connected parts are
deformed by checking body alignment dimensions. Use appropriate measurement
tools (reference rigs, templates or gauges). Straighten the body if necessary.
Use a rotary brush to remove
paint to gain access to the weld spots.1. Use a chamfering machine to remove the spot welds shown in the
figure.2. Drill out any weld spots not accessible to the chamfering machine.Use a chisel and mallet to remove spots
drilled previously.Trim the cut edges from the car.
Straighten the car edges using
a mallet and profiled stake.Use a grinding wheel to remove the spot
weld residues.Use a rotary brush to clean treated areas.1. Apply the electroweldable paint finish.
1. Use a grinding wheel to remove the corrosion-proofing from around
the inner and outer edge of the parts.
Refitting
(
Removing
)
Position the replacement part
correctly on the vehicle and secure it in place using self-locking
clamps.Check the alignment and ensure the surrounding
gaps are even.1. Use a spot welder to weld the areas shown in the figure.2. Using a MIG welder, fill weld in the areas illustrated in the
diagram.
Correct any deformations in
the panel using a profiled stake and mallet.Use a grinding wheel to level the weldsUse a rotary brush to clean the newly-welded
areas.Apply rust-proofing to newly-welded areas.Seal the joint lines between the part and
the car. - 7210B82 r r rear sacrificial beam
Removing
(
Refitting
)
- 7210B82 r r rear sacrificial
beamCheck if any of the connected parts are
deformed by checking body alignment dimensions. Use appropriate measurement
tools (reference rigs, templates or gauges). Straighten the body if necessary.
