2753367 - 1004E10 engine, removed - remove cylinder head and oil sump for inspection - includes positioning on stand and removal

 Refer to op.. 1004D40  engine - position on stand and remove . 1. Disconnect electrical connections (1a), (1b), (1c), (1d), (1e), (1f), (1g), (1h), (1i) and (1l).2. Open the wiring duct (2a) and remove the engine wiring (2b).

	Name	Connector
1a	Throttle position sensor	K56

	Name	Connector
1b	Idle actuator	N74

	Name	Connector
1c	Fuel vapour recovery solenoid	L10

	Name	Connector
1d	Engine coolant temperature sensor/sender unit	K36

	Name	Connector
1e	Injector	N70

	Name	Connector
1f	Battery earth on engine	C2

	Name	Connector
1g	Detonation sensor	K50

	Name	Connector
1h	Engine oil pressure sensor	K28

	Name	Connector
1i	Integrated air temperature sensor	K43

	Name	Connector
1l	Rpm sensor	K46

1. Remove the inlet manifold complete with injectors and throttle body.2. Remove bracket (2a) by undoing nuts (2b). 1. Undo the bolt (1a) and remove the engine oil dipstick.2. Remove the upper shield (2a) and the lower shield (2b) for the timing drive belt. 3. Release the rpm and TMS electrical lead from the fastenings on the timing belt covers and remove the rpm sensor. 1. Undo the bolts (1a) and remove the auxiliary shaft pulley on the crankshaft. 1. Loosen the timing belt moving tensioner nut.2. Remove the timing drive belt. 1. Undo the bolts (1a) and remove cam cover (1b), complete with gasket.2. Undo the bolts (2a) and remove the cylinder head (2b).3. Remove the cylinder head gasket.4. Remove both locating dowels. Rotate the engine on the overhauling stand.1. Undo nuts (1a) and bolts (1b) securing the oil sump to the crankcase.2. Using the tool (2a), cut the silicone sealant along the entire perimeter of the oil sump.

	Name	Country
2a	Blade	1.870.718.000

3. Remove the engine oil sump.