2753554 - E6021 COMPRESSOR ENGAGEMENT - Functional description (Smart gearbox)

Functional description

The engine control unit M010 receives at pin 26 connector B, the request to switch on the compressor See E6020 AIR CONDITIONING .

After receiving the request, the engine control unit:

• from pin 6 connector B, sends a negative signal to the coil of the relay T09, which provides the direct battery supply to the relay T05;
• from pin 64 connector B, sends a negative signal to the coil of the relay T05, which supplies the compressor L020.

The two relays, T05 and T09, are connected 'in cascade'; the relay T09 provides the direct battery supply to T05, and operates with the ignition-dependent supply (INT/A). The operation of both is interrupted during engine starting (key at START position). The engine control unit M010 interrupts compressor operation depending on the signal it receives as input, at pin 5 connector B, from the linear sensor K120. The sensor receives a supply and earth reference from pins 15 and 3 connector B of the engine management control unit M010. The compressor engagement is only enabled with the engine started. The 'engine started' signal is sent to pin 28 connector A of the robotized gearbox control unit M054. The information is then sent, via the C-CAN, to the engine management control unit M010 (for more details See E1050 CAN CONNECTION LINES ).