| 1 | REVERSING SWITCH OPERATION CHECK | All OK | Problems encountered | Operation |
|---|
| Connect the Examiner, enter into the fault diagnosis in the "PARAMETERS" mode (Engine management) and check the "CLUTCH PEDAL STATUS" parameter.Engage reverse and check that the switch changes status | Move on to Step 4 1 | Incorrect reading | Replace the sensor.Move on to Step 2 1 |
| 2 | REVERSING SWITCH CHECK | All OK | Problems encountered | Operation |
|---|
| Detach the connector for the switch and check its operation | Move on to Step 2 1 | The switch is not working properly | Replace the switch Op. 5550D22 REVERSING LIGHT SWITCH - R+RMove on to Step 4 1 |
| 3 | ELECTRICAL CONNECTION CHECK | All OK | Problems encountered | Operation |
|---|
| Check the electrical continuity between the reversing switch and the body computer | Move on to Step 4 1 | Electrical continuity failure between the switch and the body computer | Restore the connection.Move on to Step 4 1 |
| 4 | CHECK ON CORRECT OPERATION | All OK | Problems encountered | Operation |
|---|
| Road test the vehicle to check that the system is working properly | End of diagnosis | | |
