| | Results of the tests |
| 0 | PRELIMINARY CHECKS | All OK | Problems met | Operation |
|---|
| Turn
the key to the ON position and check that all the lights (side and
no. plate) come on when the side lights are activated.Then turn the key to the OFF position and check that the lights
remain on | End of diagnosis | The side lights doe not come on with the key
in the ON position | Continue as instructed See table I01 |
| The side lights do not remain on when the key is in the
OFF position | Continue as instructed See table I02 |
| The no. plate lights only do not work | Continue to Step 1 |
| 1 | CHECK WITH DIAGNOSTIC EQUIPMENT | All OK | Problems met | Operation |
|---|
| Connect
the Examiner to the diagnostic equipment and check that there are
no faults at the Body Computer Node | Continue to Step 2 | Presence of faults | Continue following the instructions
for the diagnostic equipment |
| 2 | ACTIVE DIAGNOSIS | All OK | Problems met | Operation |
|---|
| Keeping
the diagnostic equipment connected, check number plate light bulb
operation by mean of active diagnosis: | Continue to Step 4 | The no. plate lights do
not come on | Continue to Step 3 |
| 3 | ELECTRICAL EQUIPMENT CHECK | All OK | Problems met | Operation |
|---|
| Check
the condition of the bulbs.Check the continuity and the insulation of the wiring between
the intermediate connection and the no. plate lights connector Check the continuity and the insulation of the wiring between
the Body Computer Node and the intermediate connection See E2010 SIDE LIGHTS / NO. PLATE LIGHTS | Continue to Step 4 | Connections broken | Replace the no. plate light Op. 5540A94 |
| Connections broken | Renew the electrical connections See E2010 SIDE LIGHTS / NO. PLATE LIGHTS |
| 4 | Continue as instructed by
the tester | All
OK | Problems
met | Operation |
|---|
| Check
that the fault is no longer present | End of diagnosis | The fault persists | Replace the Body Computer Op. 5505A32 |
