2751069 - K01 REV COUNTER NOT WORKING
With the engine started, the rev counter does not work, or it works irregularly.The engine rpm message supplied by the Engine Management Control Unit Node via the Body Computer Node is made available to the Instrument Panel Node.| Results of the tests | ||||
| 0 | PRELIMINARY CHECK | All OK | Problems met | Operation |
|---|---|---|---|---|
| Check that no failure message is displayed with the engine started up | Continue to Step 2 | There are faults detected | Continue to Step 1 | |
| 1 | CHECKING WITH DIAGNOSTIC EQUIPMENT | All OK | Problems met | Operation |
| Connect
the diagnostic equipment (Examiner Plus or Smart) to the body computer. Check the following on the CAN information network:
| Continue to Step 2 | Presence of faults in the CAN network | Continue according to the instructions for the diagnostic equipment | |
| Presence of errors at instrument panel node | Continue to Step 2 | |||
| 2 | CHECKING WITH DIAGNOSTIC EQUIPMENT | All OK | Problems met | Operation |
| Connect the diagnostic equipment (Examiner Plus or Smart) to the diagnostic socket or keep it connected and check that there are no faults at the instrument panel node | Continue to Step 3 | For the presence of errors or failed dialogue with the diagnostic equipment | Continue according to the instructions for the diagnostic equipment | |
| 3 | CHECKING WITH DIAGNOSTIC EQUIPMENT | All OK | Problems met | Operation |
| Keeping the diagnostic equipment (Examiner) connected to the diagnostic socket, check the operation of the pointer through active diagnosis | Continue to Step 4 | Rev counter is not working | Replace instrument panel Op. 5560B11 | |
| 4 | Continue as instructed by the tester | All OK | Problems met | Operation |
| Check that the fault is no longer present | End of diagnosis | . | ||