X01 EXCESSIVE FUEL CONSUMPTION - Fiat - PANDA - eLearn

2751135 - X01 EXCESSIVE FUEL CONSUMPTION

The engine appears to running smoothly, but the fuel consumption is higher than previously recorded during the life of the vehicle.

The consumption data in the vehicle technical documentation has been defined during the course of homologation tests in accordance with directive 93/116/CE. These tests simulate an urban cycle and an 'average' extra-urban cycle and therefore may not be indicative as consumption depends very much on the style of driving.

0	PRELIMINARY CHECKS	All OK	Problems met	Operation
		Results of the tests
	Check the conditions: of the air filter of any leaks in the low or high pressure system obstructions in the exhaust system	Continue to Step 1	Filter element dirty or damaged	Replace the filter element Op. 1048A14
			Diesel leaks in the system	Restore system seal
			Exhaust system obstructed	Restore correct operation
1	CHECKING WITH DIAGNOSTIC EQUIPMENT	All OK	Problems met	Operation
	Connect the Examiner diagnostic equipment to the diagnostic connector and check the engine control node: for faults in error mode; for plausibility of all parameters in parameter mode;	Continue to Step 2	Presence of error P0115	Continue to Step 2
			Unreliable parameters	Continue following the instructions for the diagnostic equipment
			Presence of other errors in the control unit	Continue following the instructions for the diagnostic equipment
2	CHECK ENGINE TEMPERATURE SENSOR	All OK	Problems met	Operation
	Check the sensor signal is consistent with engine temperature	Continue to Step 3	Air temperature sensor fault	Replace sensor
3	CHECK ACCELERATOR PEDAL POTENTIOMETER	All OK	Problems met	Operation
	Check the correct operation of the accelerator pedal potentiometer as described in the test See Test 1068AB Check operation of accelerator pedal potentiometer	Continue to Step 4	Faulty potentiometer	Replace potentiometer
4	HIGH PRESSURE CHECK	All OK	Problems met	Operation
	Connect the Examiner diagnostic equipment to the diagnostic socket.: Check as described in the test See Test 1060D Check high pressure fuel circuit that the diesel pressure parameter is correct. Check the operation of the rail high pressure sensor by carrying out the test. See Test 1060GE Check on operation of diesel high pressure sensor Check the operation of the pressure regulator through active diagnosis.	Continue to Step 5	Sensor faulty	Replace sensor.
		Continue to Step 5	Pressure regulator faulty	Replace the pressure regulator
5	LOW PRESSURE CHECK	All OK	Problems met	Operation
	Check the fuel supply circuit, low pressure side: carry out test See Test 1060B Low fuel pressure supply circuit check for low delivery pressure carry out test See Test 1060A Low return fuel pressure circuit check for low return pressure	Continue to Step 6	Pressure not correct	Perform specific test for low fuel pressure supply system (filter, pipes, electric pump) to identify the faulty component
6	CHECK ON CORRECT OPERATION	All OK	Problems met	Operation
	Check that the fault is no longer present	End of diagnosisEnd of diagnosis