2752472 - 1040A20 fuel tank - r + r and decant fuel for versions with evaporation control system
Removing
(
Refitting
)
Disconnect the battery negative terminal.Move the load carrying compartment lining
away from the work area.1. Undo the rear bolts fixing the rear seat cushion.
1. Undo the front bolts fixing the rear seat cushion.2. Remove the rear seat cushion.
1. Undo the fuel filler pipe cap and remove it.2. Undo the bolts (2a) fixing the fuel filler pipe (2b).
1. Remove the submerged pump protective cover.2. Disconnect the rapid connector (2a) for the fuel supply pipe
and disconnect the electrical connection (2b) for the submerged
pump.
1. Remove the fastening clips (1a) and undo the fixing nut (1b).2. Remove the fuel tank heat shield.
Position the hydraulic lift. 1. Undo the bolts (1a) fixing the tank (1b) and remove it complete
with pipes.
Refitting
(
Removing
)
Tighten the fuel tank complete with pipes
in its housing and connect the fuel supply pipe rapid connector
to the submerged pump.Tighten the bolts fixing the fuel tank
to the bodyshell to torque.
Fastening
Component
Ø
Value(daNm)
-
Bolt
FUEL TANK
M8
(Bodyshell side) 3,5
Fit the tank heat shield and tighten the
fixing nut.Secure the exhaust pipe rubber mountings
to the housings. - 4450B08 right rear wheel r rConnect the electrical connection for the
submerged pump.Fit the submerged pump cover in place.Fit the rear seat cushion and tighten the
fastenings to torque.
Fastening
Component
Ø
Value(daNm)
-
Bolt
REAR SEAT CUSHION.
M10 x 1.25
4
Fit the load carrying compartment lining
in place.Connect the battery negative terminal.Fit the fuel filler pipe in the housing
on the bodyshell and tighten the fixing bolts.Tighten the fuel filler pipe cap.
Removing
(
Refitting
)
Disconnect the battery negative terminal.Move the load carrying compartment lining
away from the work area.1. Undo the rear bolts fixing the rear seat cushion.
