1032A12 CHAIN AND GEARS FOR TIMING SYSTEM - R.R. FOR TIMING OR REPLACEMENT. - Fiat - PANDA - eLearn

2752572 - 1032A12 CHAIN AND GEARS for timing system - R.R. for timing or Replacement.

) Remove the car from the ramps.Disconnect the battery negative terminal. - 0010T84 coolant for air conditioning system dehydrate and recharge - 1088B10 engine cooling tank - r + r - 1008B10 power unit front mount (timing side) flexible block - replace - 1008A47 rigid power-unit mount - timing side - r r for versions with air conditioner - 4450B04 right front wheel r r - 1092G11 Engine components single drive BELT - R.R. for versions with air conditioning - 1092A12 crankshaft pulley - r+r for versions with air conditioner - 2110A60 manual gearbox/engine coupling bracket - r+r - 1020A20 crank case oil sump - r + r clean seals for sealant application - 1020B12 TIMING COVER with drive chain - R.R. and REPLACE. gasket for versions with air conditioning1. Undo the bolt securing the driven timing pulley.

Mark the installation position of the exhaust side toothed drive pulley, the toothed drive pulley and the timing drive chain (if the removed chain is being reused); If the pulleys are replaced, fit them with the writing turned to the outside.

2. Remove the timing chain (2a) together with the driven timing pulley (2b) and the toothed drive pulley (2c).Using suitable equipment, prepare the moving tensioner and keep it fully retracted using a suitable retaining pin.

Refitting ( Removing

) 1. Refit the timing chain (1a) together with the driven timing pulley (1b) and the toothed drive pulley (1c).2. Tighten the bolt securing the toothed driven pulley to the specified torque.

	Fastening	Component	Ø	Value(daNm)
2	Bolt	TIMING DUCT PULLEY	M12	(Exhaust camshaft side) 10.8 ÷ 13.2

Remove the pin from the moving tensioner and check that the moving tensioner piston is in contact with the plate. - 1020B12 TIMING COVER with drive chain - R.R. and REPLACE. gasket for versions with air conditioning - 1020A20 crank case oil sump - r + r clean seals for sealant application - 2110A60 manual gearbox/engine coupling bracket - r+r - 1092A12 crankshaft pulley - r+r for versions with air conditioner - 1092G11 Engine components single drive BELT - R.R. for versions with air conditioning - 4450B04 right front wheel r r - 1008A47 rigid power-unit mount - timing side - r r for versions with air conditioner - 1008B10 power unit front mount (timing side) flexible block - replace - 1088B10 engine cooling tank - r + r - 0010T11 engine oil check level and top up - 0010T20 coolant change - 0010T84 coolant for air conditioning system dehydrate and rechargeConnect the battery negative terminal.Remove the car from the ramps.