1084C12 ENGINE OIL HEAT EXCHANGER, COMPLETE WITH ENGINE OIL FILLER AND FILTER - R.R. - Fiat - PANDA - eLearn

2752635 - 1084C12 Engine oil HEAT EXCHANGER, complete with engine oil filler and filter - R.R.

) Disconnect the battery negative terminal.1. Disconnect the electrical connection from the air flow meter.

	Name	Connector
1	Air flow meter	K41

2. Loosen the band and disconnect the the turbocharger air inlet sleeve from the rigid pipe, air flow meter side.

1. Remove the air filter (1a) complete with air flow meter (1b) by releasing from the underlying pins and then from the rear fastenings.

1. Loosen the band and disconnect the lower radiator coolant outlet hose from the radiator, engine oil heat exchanger end.

Drain the coolant into a suitable container.

1. Undo the connectors (1a) and remove the engine oil supply pipe to the turbocharger (1b).

1. Undo the bolts fixing the coolant supply pipe to the engine oil heat exchanger, crankcase side.2. Undo the bolts fixing the coolant supply pipe to the engine oil heat exchanger, heat exchanger side.3. Move aside the pipe carrying coolant to the engine oil heat exchanger (3a) complete with seal (3b).

1. Undo the bolts (1a) and remove the engine oil heat exchanger complete with filter and engine oil filler (1b) and gasket.

Collect the engine oil which comes out in a suitable container.

Refitting ( Removing

) 1. Refit in its seating the engine oil heat exchanger complete with filter and engine oil filler (1a) and gasket, and secure with the bolts (1b) to the specified torque.

Make sure that the gasket is undamaged and correctly positioned.

	Fastening	Component	Ø	Value(daNm)
1b	Bolt	ENGINE OIL HEAT EXCHANGER	-	(Engine crankcase side) 0.8 ÷ 1.0

Fit the engine oil heat exchanger coolant inlet pipe, complete with gasket, in position.

Fold back the gasket tabs

Undo the bolts fixing the coolant supply pipe to the engine oil heat exchanger, heat exchanger side, to the specified torque.Tighten the coolant inlet hose bolt to the engine oil heat exchanger, crankcase side.1. Fit the turbocharger engine oil supply pipe (1a) in place and secure it tightenining the connectors (1b) to the recommended torque.

	Fastening	Component	Ø	Value(daNm)
1b	Connector	OIL DELIVERY PIPE TO TURBO	M10	(Turbocharger side/engine oil heat exchanger) 1.1 ÷ 1.3

Refit the lower coolant outlet sleeve from the radiator, engine oil heat exchanger end, and tighten the band.Fit the air filter complete with air flow meter in place.Connect the air intake sleeve to the turbocharger, air flow meter side, and tighten the band.Connect the electrical connection to the air flow meter.

	Name	Connector
-	Air flow meter	K41

Connect the battery negative terminal. - 0010T20 coolant change