2753580 - Introduction - REMOVING REFITTING

WARNINGS

The graphic index and the description of the symbols appearing in the repair procedures are given below.

SYMBOLS

.
1. Cut with hack-sawing machine 2. Cut with circular saw 3. Clean with rotary brush 4. Remove spot welds with spot weld remover 5. Removing spot welds with spot weld remover Drilling for MIG welding 6. Preparing panel using chisel Drilling for MIG welding 7. Application of electro-weldable protection 8. Application of thick electro-weldable protection 9. Centring components 10. Measurement 11. Fixing components 12. Fixing threaded rivets 13. Checking alignment gaps 14. Straightening edges with profiled stake and hammer 15. Removing weld spots with chisel and hammer 16. Removing treatment with pneumatic knife 17. Spot welding 18. MIG welding 19. Welding with oxyacetylene torch 20. Grinding 21. Application of anti-corrosion protection 22. Application of sealants 23. Application of underbody protections 24. Application of paints 25. Application of wax-based protection 26. Application of foam products 27. Heating with hot air 28. Removing panel offcuts

PROCESSING SYMBOLS

The symbols are given below of the work tasks which are described in the repair procedures with an example of application. In the descriptions of the procedures, beside the progressive number of the steps of the procedure relating to welding tasks, there may be numbers in brackets which indicate the number of spot welds to be made or to be filled by MIG welding.Cut made by hack saw or pneumatic chisel

PROCESSING SYMBOLS

Spot welding

PROCESSING SYMBOLS

Spot welding (three panels)

PROCESSING SYMBOLS

Continuous - sectional MIG welding

PROCESSING SYMBOLS

Brazing

PROCESSING SYMBOLS

MIG fill welding

PROCESSING SYMBOLS

Sealing