184000765 - 0010T67 HYDRAULIC CLUTCH SYSTEM BLEED AIR

Position the vehicle on the ramp.Check that the brake-clutch fluid in the reservoir is at the maximum level; if not, top up with the recommended fluid.

	Type	Component	Name	Qty.
-	Synthetic fluid (kg)	BRAKE-CLUTCH HYDRAULIC SYSTEM	TUTELA TOP 4	0.55

The symbol on the container identifies synthetic type brake fluids as opposed to mineral type brake fluids. The use of mineral type fluids irreparably damages the special rubber seals in the hydraulic braking system.

Take great care to avoid the brake fluid, which is highly corrosive, from coming into contact with the paintwork. If this should happen, wash immediately with water.

Proceed with removal    Op. 5530B10 BATTERY - R+R.Proceed with removal    Op. 5530B52 BATTERY DRIP TRAY/SUPPORT - R.R..1. Connect the tool to the brake-clutch fluid reservoir.

	Name	Country
1	Anti-pollution	1.806.097.000

2. Remove the cap on the bleed valve.3. Connect the collection system (pipe and reservoir) to the bleed valve on the master cylinder.4. Slacken the bleed screw;5. Slowly open the fluid reservoir cock.Wait until all the air contained in the hydraulic system has emerged.Tighten the bleed screw.

Bleed screw tightening torque should not exceed 0.35 daNm.

Remove the fluid collection devices.Place the cap in its housing on the bleed valve.Remove the equipment.

	Name	Country
-	Anti-pollution	1.806.097.000

During the bleeding, refill the brake-clutch fluid reservoir, as necessary.

The collected brake/clutch fluid must not be reused. The level should always be topped up with new fluid.

Proceed with refitting    Op. 5530B52 BATTERY DRIP TRAY/SUPPORT - R.R..Proceed with refitting    Op. 5530B10 BATTERY - R+R.Remove the car from the ramps.Check correct clutch disengagement and gear engagement.

If, after having carried out the bleeding operation, the system is not fully operational, repeat the entire procedure after having waited several hours for the brake fluid to settle down in the system.