Removing
(
Refitting
)
Ensure that the ignition key is in the OFF position, then disconnect the negative battery terminal (-).
Name
Connector
-
Battery
A1B
1. Move the upper section of the floor covering near the passenger side dashboard aside.2. Disconnect the electrical connection from the inertia switch.
Name
Connector
2
Inertial switch
I50
3. Undo retaining nuts (3a) and remove inertia switch (3b)
Refitting
(
Removing
)
Place the inertia switch back in its housing.Connect the electrical connection to the inertia switch.Tighten the inertia switch fixing nuts.Put the floor trim back in its place.Connect the negative (-) battery terminal.
Removing
(
Refitting
)
Ensure that the ignition key is in the OFF position, then disconnect the negative battery terminal (-).
