184001187 - 2710A54 L/H OR R/H WHEEL END CONSTANT VELOCITY JOINT (ONE) - R + R WITH DRIVE SHAFT REMOVED - INCLUDING BOOT REPLACEMENT

Removing ( Refitting ) Place the drive shaft in a vice fitted with protective jaws.1. Remove the protective boot fastening bands.2. Move the protective boot back.3. Remove the wheel side constant velocity joint (3a) using the tools (3b) and (3c) using pliers on the circlip (3d) at the same time.

NameCountry
3bCounter weight1.847.017.000

NameCountry
3cAdaptor1.860.889.000
Remove the circlip locking the constant velocity joint, wheel side.Remove the protective boot.
Refitting ( Removing ) Clean the residual grease of the components and check their condition.Fit a new protective boot on the driveshaft.Refit the constant velocity joint, wheel side, back in its seating complete with a new circlip.Refit the gaiter back in its seating, then fill it with the recommended grease.

TypeComponentNameQty.
-Grease (g)WHEEL END CONSTANT VELOCITY JOINTTUTELA STAR 500-
Fasten the protective boot using the bands.Remove the driveshaft from the vice.