184001211 - 3330B02 PEDAL ASSEMBLY - R R

Removing ( Refitting ) Proceed with removal 7040L37 gear lever plate - r r Proceed with removalProceed with removal 7040A65 passenger compartment box lock , one , r r Proceed with removalProceed with removal 7040A19 cushion padding - r r Proceed with removalProceed with removal    Op. 7040A28 TRIM ON GEARBOX CONTROL PANEL - R.R.Proceed with removalProceed with removal 7040A30 Left instrument panel lower TRIM - R.R. Proceed with removalProceed with removal    Op. 5580C18 AIR BAG MODULE - R+R1. Working at the rear of the brake pedal, press the white coloured retaining tabs (1a) which secure the brake servo push rod (1b) to the brake pedal (1c).
Closely observe the safety regulations established for this operation    Op. 5580C AIR BAG SYSTEM.
4110A11 steering wheel - r+r for replacement or check for versions with air bag 5550A12 complete stalk unit - r+r for versions with air bag     Op. 4110D20 STEERING ELECTRICAL CONTROL DEVICE - R R 1060G42 clutch pedal switch - r r 1060G38 brake pedal switch - r r
1. Remove the black coloured retaining device (1a), then release the brake servo push rod (1b) from the brake pedal (1c) and keep the cover (1d) for the brake servo push rod spherical head seat.
After each dismantling operation the black coloured retaining device (1a) for the brake servo push rod must always be replaced even if it appears to be intact.
1. Release the retaining clips (1a) and disengage the clutch master cylinder push rod (1b) from the pedal.
1. Undo the nuts (1a) and remove the pedal assembly (1b).
Refitting ( Removing ) 1. Fit the pedal assembly (1a) back in its housing and tighten the nuts (1b) to the specified torque.

FasteningComponentØValue(daNm)
-NutPEDALSM8(Brake servo/bodyshell side) 1.8 ÷ 2.6
Connect the clutch pedal by replacing in its seat and press the pedal fully down.1. Fit the new retaining device (1a) onto brake pedal (1b) to secure the retaining clips (1c). Position the cover (1d) for the brake servo push rod spherical head.
After each dismantling operation the black coloured retaining device (1a) for the brake servo push rod must always be replaced even if it appears to be intact.
Lift up the brake pedal and position the brake servo push rod by the retaining device.Press the brake pedal to engage the brake servo push rod with the retaining device.Proceed with refitting 1060G38 brake pedal switch - r r .Proceed with refitting 1060G42 clutch pedal switch - r r .Proceed with refitting    Op. 4110D20 STEERING ELECTRICAL CONTROL DEVICE - R R.Proceed with refitting 5550A12 complete stalk unit - r+r for versions with air bag .Proceed with refitting 4110A11 steering wheel - r+r for replacement or check for versions with air bag .Proceed with refitting    Op. 5580C18 AIR BAG MODULE - R+R.Proceed with refitting 7040A30 Left instrument panel lower TRIM - R.R. .Proceed with refitting    Op. 7040A28 TRIM ON GEARBOX CONTROL PANEL - R.R..Proceed with refitting 7040A19 cushion padding - r r .Proceed with refitting 7040A65 passenger compartment box lock , one , r r .Proceed with refitting 7040L37 gear lever plate - r r .