7005A08 INTERIOR SUPPORT FRAME OF ONE SIDE DOOR R R WITH DOOR PANEL REMOVED - Lancia - MUSA - eLearn

184001539 - 7005A08 INTERIOR SUPPORT FRAME OF ONE SIDE DOOR R R WITH DOOR PANEL REMOVED

) 1. Open the cover giving access to the glass retainer.2. Provisionally connect the switch unit to its electrical connection (2a) and move the retainer (2b) of the glass (2c) to the access position (as illustrated in the figure).3. Disconnect the retainer (2b) from the glass, then lift the glass (2c) to the end of its travel and secure it in this position with a hook (3a).

1. Disconnect electrical connections (1a) and (1b).

	Name	Connector
1a	Anti-crush safety sensor on side front door	K22

	Name	Connector
1a	Anti-crush safety sensor on side front door	K23

	Name	Connector
1b	Driver''s external rear view mirror	P60

	Name	Connector
1b	Exterior passenger side rear view mirror	P61

2. Disconnect the electrical cable retainer.3. Lift the ring nut (3a) and disconnect the door''s electrical connection (3b).

	Name	Connector
3b	Rear coupling for /front door. driver''s side	D30

	Name	Connector
3b	Front passenger door/ rear coupling.	D31

4. Introduce the door electrical connection as far as possible into the door.5. Undo the perimetral bolts.6. Release and push inwards the seal (6a) for the door opening cable pass (6b).

1. Move the frame slightly.2. Connect electrical connections (2a) and (2b).

	Name	Connector
2a	Front driver''s door lock geared motor.	N50

	Name	Connector
2a	Passenger front. door lock geared motor	N51

	Name	Connector
2b	Driver''s front door locking/unlocking switch	I26

3. Remove the frame (3a), releasing it from the door opening cable (3b).

If necessary, continue 7205E37 STRIPPING FRONT SIDE DOOR INNER SUPPORT FRAME

Refitting ( Removing

) Check that the frame is not damaged.1. Before positioning the frame (1a), check that the perimeter seal (1b) is intact and clean. Also check that the support surface of the door frame is clean.

Offer the frame to its seating, securing the door opening cable and connecting the electrical connections.Fit the frame, position the seal and door electrical connection and tighten the bolts.Connect the door electrical connection and fit the ring nut.Connect the mirror and anti-pinch sensor electrical connections and secure the cable correctly.Connect the window retainer and close the access cover.