184001596 - 7010A14 REAR SIDE DOOR - ADJUST CENTERING AND MOULDING - INCLUDES ADAPTATION OF HINGESAND SEALS ON DOOR COMPARTMENT

1. If adjustment is made after removing the door, tighten the hinge bolts to the specified torque.

FasteningComponentØValue(daNm)
1BoltREAR SIDE DOOR HINGESM61.5
2. If the hinges were removed from the door previously, tighten the hinge bolts.3. Undo the bolt (3a) of the door check strap (3b) and close the door again to push the check strap back in.
1. Loosen the bolts securing the hinges to the bodyshell.2. Adjust the door position, making use of the bolt slots, so that it is perfectly aligned with the body.
It is advisable to work on one hinge at a time. Possible adjustment movements are indicated by arrows.
Fit shims between hinge and door if necessary to ensure the door is adjusted properly, proceeding as follows (the hinge position is adjusted using the door as reference).Remove the door striker, see op. 7010B143. Loosen the bolts securing the hinges to the bodysheel.4. Fit the shims.Screw in the bolts without tightening.Adjust the door position, making use of the movements of the bolt attachment plate, so that it is perfectly aligned with the body.Refit the door striker.    Op. 7010B14 REAR SIDE DOOR CATCH STRIKER R R5. After adjustment, tighten the bolts securing the hinges to the bodyshell.

FasteningComponentØValue(daNm)
5BoltREAR SIDE DOOR HINGESM10 x 1.257.9
Touch up the paintwork in the hinge area.Make the door check strap come out and tighten the bolts.

FasteningComponentØValue(daNm)
-BoltREAR DOOR OPENING LIMITERM81.5
Check that the striker and catch fit together properly    Op. 7010B14 REAR SIDE DOOR CATCH STRIKER R R.