184001623 - 7010E50 REAR SIDE DOOR PILLAR TRIM (ONE) LH OR RH - R R
Removing
(
Refitting
)
Op. 7010E10 REAR SIDE DOOR INNER PANEL - R R OR REPLACE Op. 7010D26 REAR SIDE DESCENDING WINDOW GLASS SCRAPER (OUTER) R R Op. 7010D18 REAR SIDE DOOR DESCENDING WINDOW GLASS CHANNEL R R 7010D19 RAIN GUTTER FOR DESCENDING WINDOW GLASS (one) for rear side door on vehicles with anti-crush safety sensor, left or right - R.R. (alternatively) 7010D33 channel of door descending glass inner guide (one) lh or rh, of rear side door - r r 7010A50 rear side door anti-wind noise seal r r (for front pillar trim only)1. Heat up the trim with hot air, then remove it.
Refitting
(
Removing
)
Use new trim.1. Thoroughly clean any adhesive residues from the fitting area using heptane. Bathe the fitting area in soapy water.2. Remove the protection from the adhesive side of the lining, then place it in position. The soapy water facilitates the sliding needed for the correct positioning.3. Using a sponge, press on the trim to remove any air bubbles.