Removing
(
Refitting
)
Check if any of the connected parts are deformed by checking body alignment dimensions. Use appropriate measurement tools (reference rigs, templates or gauges).If necessary, straighten the body before cutting the part.
Use a rotary brush to clean the area to be welded in order to expose the weld spots.1. Drill out the spot welds shown in the figure.Remove the front wing headlamp seat beam from the front beam.
Use a grinding wheel to remove the weld spot residues on the body.1. Apply the electroweldable paint finish.
Remove the corrosion-proofing from around the inner and outer edge of the part.1. Apply electroweldable paint finish to the edges in contact with the car.
Refitting
(
Removing
)
1. Position the front wing beam correctly on the car using self-locking clamps.2. Fit the front wings.3. Position the bonnet.Check the alignment and ensure the surrounding gaps are even.Remove the parts used for alignment.
1. Use a spot welder to weld the areas shown in the figure.
1. Use a grinding wheel to level weld residues and remove.Use a grinding wheel to remove and level weld residues in the affected area.
1. Apply rust-proofing to newly-welded areas.Apply paint.2. Apply wax.
Removing
(
Refitting
)
Check if any of the connected parts are deformed by checking body alignment dimensions. Use appropriate measurement tools (reference rigs, templates or gauges).If necessary, straighten the body before cutting the part.
