184000768 - 0010T47 HYDRAULIC SYSTEM FLUID FOR GEARBOX WITH HYDRAULIC SELECTION CHECK LEVEL AND TOP UP IF NECESSARY (Robotized gearbox)
- The quantity of fluid required to refill the reservoir only is 600 cc
- The quantity of fluid required to refill the hydraulic circuit and the reservoir is 700 cc
 | The Selespeed gearbox fluid level should be checked with the fluid at ambient temperature (engine cold). |
- Position the vehicle on a lift.
- Turn the ignition key to the ON position.
- Carry out 10 gear changes with the engine switched off (this operation is necessary to collect any traces of oil through recirculation).
- Connect the Examiner diagnostic equipment.
- Select and run the "accumulator depressurization" service.
- At the end of the above operation, the electro-hydraulic selection gearbox reservoir will be full of fluid.
- Op. 5530B10 BATTERY - R+R
- Op. 5530B52 BATTERY DRIP TRAY/SUPPORT - R.R.
- Op. 2127C13
- Check that the level corresponds to the MAX reference on the reservoir.
- If the level is below the MIN mark, add the recommended fluid until the level is midway between the MIN and MAX marks.
| Type | Component | Description | Qty. | |
|---|---|---|---|---|
| - | Fluid [I] | HYDRAULIC GEARBOX HYDRAULIC SYSTEM | Tutela car cs speed |
- Retighten the cap and check that the breater pipe is correctly inserted.
- Op. 2127C13
- Op. 5530B52 BATTERY DRIP TRAY/SUPPORT - R.R.
- Op. 5530B10 BATTERY - R+R
- Remove the vehicle from the lift.