2127E44 HYDRAULIC SELECTION GEARBOX CLUTCH POSITION SENSOR - R R - Lancia - MUSA - eLearn

184001170 - 2127E44 HYDRAULIC SELECTION GEARBOX CLUTCH POSITION SENSOR - R R

) Place the gear lever in neutral, N.Proceed with removal Op. 5530B10 BATTERY - R+R.Proceed with removal Op. 5530B52 BATTERY DRIP TRAY/SUPPORT - R.R..1. Disconnect the electrical connection from the electro-hydraulic gear selection clutch position sensor.

	Name	Connector
1	Clutch position potentiometer	See K95 CLUTCH POSITION POTENTIOMETER

2. Undo the bolts (2a) and remove the clutch position sensor (2b).3. Undo the bolts (3a) and remove the clutch position signal relay (3b).

Refitting ( Removing

) 1. Fit the clutch position signal relay making sure to match the fork (1a) with the engagement pin (1b) and secure it with its bolts.

Fit the sensor on the clutch position signal relay making sure to charge the potentiometer.

The potentiometer is charged by engaging the sensor on the clutch position signal relay drive shaft and making it rotate by ninety degrees compared to the final fitting position.

Connect the electrical connection to the gear position sensor.Proceed with refitting Op. 0010T47 HYDRAULIC SYSTEM FLUID FOR GEARBOX WITH HYDRAULIC SELECTION CHECK LEVEL AND TOP UP IF NECESSARY.Proceed with refitting Op. 0010T48 HYDRAULIC SYSTEM FOR GEARBOX WITH HYDRAULIC SELECTION BLEED AIR.Proceed with refitting Op. 5530B52 BATTERY DRIP TRAY/SUPPORT - R.R..Proceed with refitting Op. 5530B10 BATTERY - R+R.Connect an Examiner, initialise the gear engagement/selection positions and check the engagement travel is correct.