Removing
(
Refitting
)
Ensure that the ignition key is in the OFF position, then disconnect the negative battery terminal (-).
Name
Connector
-
Battery
A1B
Proceed with removal 3380A44 handbrake/linkage protection - r+r Proceed with removal1. Disconnect the electrical connection from the hill holder longitudinal sensor. Op. 7040L20 TUNNEL TRIM - R R2. Undo the nuts (2a) and remove the hill holder longitudinal acceleration sensor (2b).
Refitting
(
Removing
)
Refit the hill holder longitudinal acceleration sensor and secure with nuts.Connect the hill holder longitudinal acceleration sensor electrical connection.Proceed with refitting Op. 7040L20 TUNNEL TRIM - R R.Proceed with refitting 3380A44 handbrake/linkage protection - r+r .Connect the negative (-) battery terminal.Calibrate the longitudinal acceleration sensor following the procedure indicated by the Examiner test station.
Removing
(
Refitting
)
Ensure that the ignition key is in the OFF position, then disconnect the negative battery terminal (-).
