184001301 - 4450A10 FRONT WHEEL GEOMETRY - CHECK USING OPTICAL EQUIPMENT - INCLUDES FRONT WHEEL TOW-IN ADJUSTMENT IF NECESSARY

The front wheel geometry should be checked after having subjected the components which affect the wheel geometry to the following checks:

  • tyre inflation pressure;
  • the eccentricity and orthogonality of the wheel rims should not exceed 3 m;
  • wheel bearings end float;
  • clearance between steering knuckle and track control arm ball joint;
  • steering rod ball joint clearance.
After having carried out the above checks, position the vehicle (in running order) on a lift equipped with the test equipment.CHECKING WHEEL GEOMETRY1. Check that the front wheel geometry is within the recommended limits. the geometry is measured by checking the distance from the ground at the front wing maximum curvature point.The geometry values are supplied with Standard A.Standard A = unladen vehicle including spare wheel, tools, accessories and fluids (full fuel tank).

MeasurementValue
-- (mm)652 +/- 5
Standard A (-)-
CHECK ON TOE-INCheck that the front wheel toe in is within the recommended limits.The toe in values are supplied with standard A.Standard A = unladen vehicle including spare wheel, tools, accessories and fluids (full fuel tank).

MeasurementValue
-1a - 1b (mm)0.1 ± 1
Standard A (-)-
If the front wheel toe-in is not correct, adjust it as described below.TOE IN ADJUSTMENTStraighten the steering wheel perfectly, and lock it in this position with a suitable tool.Loosen the bands fastening the steering box boots to the steering rods.1. Loosen the rod lock nuts.2. Tighten or loosen the steering box rods until the toe in value is correct, keeping the front wheels aligned.Tighten the steering rod lock nuts to the specified torque.

FasteningComponentØValue(daNm)
-NutADJUSTABLE STEERING LINKSM12(Steering box side) 4.5 ÷ 5.5
Tighten the bands fastening the steering box boots to the steering rods.Remove the tool used for locking the steering wheel.
CHECK ON CAMBER
The front wheel camber is not adjustable. If the value measured is not within the recommended limits, check the lower track control arm and the bodyshell.
1. Check that the front wheel camber is within the recommended limits.The camber values are supplied with standard A.Standard A = unladen vehicle including spare wheel, tools, accessories and fluids (full fuel tank).

MeasurementValue
-Standard A (-)-30' ± 30'
Standard A (-)-
CHECK ON CASTER
The front wheel caster cannot be adjusted. If the value is not within the recommended limits, check the lower track control arm and the bodyshell.
1. Check that the front wheel caster is within the recommended limits.The caster values are supplied with standard A.Standard A = unladen vehicle including spare wheel, tools, accessories and fluids (full fuel tank).

MeasurementValue
-- (mm)2° 55' ± 30'
Standard A (-)-