184001365 - 5040A60 PIPE FROM CONDENSER TO EVAPORATOR (EXPANSION PIPE) - R+R

Removing ( Refitting ) Position the vehicle on a lift.Drain the coolant (    Op. 0010T84 COOLANT FOR AIR CONDITIONING SYSTEM DEHYDRATE AND RECHARGE).    Op. 4450B04 RIGHT FRONT WHEEL R R    Op. 7055B91 RIGHT FRONT SUPPLEMENTARY WHEEL ARCH R R    Op. 7055B66 ENGINE BAY DUSTGUARD PROTECTION IN RIGHT FRONT WHEEL ARCH R R    Op. 7210E10 FRONT BUMPER1. Disconnect the electrical connection for the linear pressure switch.

	Description	Connector
1	Linear sensor for fans	K120

2. Undo the bolt (2a) and disconnect the connector (2b) for the pipe from the condenser to the evaporator.

Seal the connectors that have been disconnected using suitable plugs to prevent dampness and impurities from entering the system.

1. Working in the right front wheel arch, release the pipe from the condenser to the evaporator (1a) from the retainer (1b). Lower the vehicle.1. Working in the area of the compressor, release the fuel pipes (1a) and fuel vapour pipes (1b) from the retainers (1c).2. Release the pipe from the condenser to the evaporator (2a) from the retainers (2b). 1. Undo the bolt (1a) and disconnect the connector (1b) from the expansion valve (1c).2. Remove the pipe from the condenser to the evaporator. 1. If necessary, undo the linear pressure switch. Refitting ( Removing ) Check that the pipe from the condenser to the evaporator is not damaged and that there are no cracks that could compromise the seal.

Replace the O rings for the connectors. Only use green coloured seals that are resistant to R134a coolant. Lubricate the connector threads using anti-freeze.

1. If removed, tighten the linear pressure switch in place.

	Fastening	Component	Ø	Value(daNm)
2b	-	LINEAR PRESSURE SWITCH	-	0.8

1. Place the pipe from the condenser to the evaporator in position.2. Connect the connector (2a) for the pipe from the condenser to the evaporator, evaporator side and secure it tightening the bolt (2b) to the recommended torque.

	Fastening	Component	Ø	Value(daNm)
2b	Bolt	COOLANT SYSTEM FITTINGS	M6	0.9

Attach the pipe to the retainers.Attach the fuel and fuel vapour pipes to the respective retainers.Raise the vehicle.Working in the right front wheel arch, attach the pipe from the condenser to the evaporator to the respective retainer.1. Connect the connector (1a) for the pipe from the condenser to the evaporator, condenser side and secure it tightening the bolt (1b) to the recommended torque.

	Fastening	Component	Ø	Value(daNm)
1b	Bolt	COOLANT SYSTEM FITTINGS	M6	0.9

2. Connect the electrical connection for the linear pressure switch.     Op. 7210E10 FRONT BUMPER    Op. 7055B66 ENGINE BAY DUSTGUARD PROTECTION IN RIGHT FRONT WHEEL ARCH R R    Op. 7055B91 RIGHT FRONT SUPPLEMENTARY WHEEL ARCH R R    Op. 4450B04 RIGHT FRONT WHEEL R RRecharge the coolant (    Op. 0010T84 COOLANT FOR AIR CONDITIONING SYSTEM DEHYDRATE AND RECHARGE.Remove the vehicle from the lift.