184000640 - Z93 NBC MISSING ERROR

Ошибка в шаблоне. В ближайшее время мы ее исправим. (Error in Templaite)

This error is signalled if the control unit does not detect the body computer

	Results of the tests
1	CAN CONTROL UNITS FAULT DIAGNOSIS	All OK	Problems encountered	Operation
	Carry out a fault diagnosis using the Examiner on the CAN control units to check for the presence of errors at the NBC - NPL	Move on to Step 2	Presence of errors at CAN control units	Solve the problem for the control unit where the error is present
			Errors present in the Body Computer	Solve the problem for the Body Computer
2	CAN IMPEDANCE CHECK	All OK	Problems encountered	Operation
	Check the correct CAN impedance by carrying out Test 5505OA,    See Test 5505 INSTRUMENT/GUAGE ELECTRICAL WIRING	Move on to Step 6	ABS control unit impedance not correct	Replace the ABS control unit    Op. 3340A12 ABS HYDRAULIC AND ELECTRONIC CONTROL UNIT
			Connector side impedance not correct	Restore the power supply and move on to Step 6
3	SUPPLY CHECK	All OK	Problems encountered	Operation
	Check the Body Computer power supply	Move on to Step 6	Body Computer power supply failure	Restore the Body Computer power supply
4	CAN COMMUNICATION CHECK	All OK	Problems encountered	Operation
	Check that error U1701 (NCM missing) and that error U1717 (NGE missing) are not also present in the ABS control unit with the counter equal to or close to the reading for U1700	Move on to Step 6	Errors U1717 and U1701 present	Proceed as instructed in the    See table Z80 ENGINE CAN MESSAGE ERROR
			Error U171 only present	Proceed as instructed in the    See table
5	ELECTRICAL CHECKS	All OK	Problems encountered	Operation
	Check the continuity of the wiring for the CAN between the NGE and NBC    See E7020 ABS	Move on to Step 6	Wiring faulty	Restore the correct connection between the NGE and NBC
6	CHECK ON CORRECT OPERATION	All OK	Problems encountered	Operation
	Delete the errors using the diagnostic equipment. Carry out the road test    See Test 3350EA ESP SYSTEM ACTUATION CHECKto ensure that the control unit checks whether the errors are still present. Return to the workshop and check that the fault is no longer present using the diagnostic equipment	End of diagnosis	The fault persists	Move on to Step 1