D36 ENGINE COOLANT OVERHEATING SIGNALLED BY THE INSTRUMENT / WITH VISIBLE VAPOUR VENTING - Lancia - MUSA - eLearn

184000420 - D36 ENGINE COOLANT OVERHEATING SIGNALLED BY THE INSTRUMENT / WITH VISIBLE VAPOUR VENTING

1	PRELIMINARY CHECKS	All OK	Problems met	Operation
		Results of the tests
	Preliminarily check: the coolant level that there are no leaks that there is no engine oil in the expansion tank that the cooling radiator is not distorted or faulty that the radiator is not dirty / blocked	Continue to Step 0	Level not correct	Top up level
			Leaks detected	Move on to the step concerned
			Engine oil present	Replace the cylinder head gasket
			Radiator distorted	Reaplce the radiator
			Radiatoar dirty/blocked	Clean/wash the radiator Op. 1088A20
1	CAP SEAL CHECK	All OK	Problems met	Operation
	Check the seal of the expansion tank cap	Continue to Step 2	Cap defective	Replace the cap
2	CHECK WITH DIAGNOSTIC EQUIPMENT	All OK	Problems met	Operation
	Connect the diagnostic equipment (Examiner or other instruments) to the diagnostic socket. Check that there are no errors memorized Carry out active diagnosis of fan Check the fan operating cycle	Continue to Step 5	There are errors in the control unit	Continue according to the instructions for the diagnostic equipment
		Continue to Step 5	Operation inconsistent	Continue to Step 3
3	ENGINE COOLING ELECTRICAL CIRCUIT CHECK	All OK	Problems met	Operation
	Check that the fan control/power line is working properly See E5020 ENGINE COOLING	Continue to Step 4	Connections not correct	Restore the connections See E5020 ENGINE COOLING
4	FAN OPERATION CHECK	All OK	Problems met	Operation
	Supply the fan directly and check its operation See E5020 ENGINE COOLING	Continue to Step 5	Fan not working	Replace the fan Op. 1088E10
5	THERMOSTAT OPERATION CHECK	All OK	Problems met	Operation
	Bleed the cooling systemCheck that the thermostat is working properly	Continue to Step 6	Thermostat not working	Replace the thermostat Op. 1088C30
6	CHECK ON WATER PUMP	All OK	Problems met	Operation
	Check that the water pump is working properly	Continue to Step 7	Pump faulty	Replace the pump Op. 1088C10
7	COOLING SYSTEM LEAKAGE CHECK	All OK	Problems met	Operation
	Carry out the cooling system leak test Op. 0510C30	Continue to Step 10	No seal with visible leaks	Eliminate the leaks
	Carry out the cooling system leak test Op. 0510C30	Continue to Step 10	No seal without visible leaks	Continue to Step 8
8	HEAD HYDRAULIC LEAKAGE TEST	All OK	Problems met	Operation
	Check the hydraulic seal of the cylinder head Op. 1016E04	Continue to Step 9	Seal ineffective	Renew the seal, if necessary replace the head
9	MONOBLOCK HYDRAULIC SEAL TEST	All OK	Problems met	Operation
	CHECK ON BLOCK HYDRAULIC SEAL	Continue to Step 10	Seal ineffective	Renew the seal, if necessary replace the engine block
10	CHECK ON CORRECT OPERATION	All OK	Problems met	Operation
	Check that the fault is no longer present	End of diagnosis	The fault persists