D37 ENGINE COOLANT OVERHEATING SIGNALLED BY THE INSTRUMENT / WITHOUT VISIBLE VAPOUR VENTING - Lancia - MUSA - eLearn

184000421 - D37 ENGINE COOLANT OVERHEATING SIGNALLED BY THE INSTRUMENT / WITHOUT VISIBLE VAPOUR VENTING

1	CHECK WITH DIAGNOSTIC EQUIPMENT	All OK	Problems met	Operation
		Results of the tests
	Connect the diagnostic equipment (Examiner or other instruments) to the diagnostic socket and check: that there are no control unit errors at the CAN	Continue to Step 2	There are errors in the control unit(s)	Carry out the specific test for the faulty control unit and continue following the instructions for the diagnostic equipment
2	CHECK WITH DIAGNOSTIC EQUIPMENT	All OK	Problems met	Operation
	Keeping the diagnostic equipment (Examiner or other instruments) connected to the diagnostic socket: Carry out active diagnosis of fan Check the fan operating cycle	Continue to Step 5	Operation inconsistent	Continue to Step 3
3	ENGINE COOLING ELECTRICAL CIRCUIT CHECK	All OK	Problems met	Operation
	Check that the fan control/power line is working properly See E5020 ENGINE COOLING	Continue to Step 4	Connections not correct	Restore the connections See E5020 ENGINE COOLING
4	FAN OPERATION CHECK	All OK	Problems met	Operation
	Supply the fan directly and check its operation See E5020 ENGINE COOLING	Continue to Step 5	Fan not working	Replace the fan Op. 1088E10
5	COOLANT TEMPERATURE SENSOR CHECK	All OK	Problems met	Operation
	Check that the sensor is working properly.	Continue to Step 6	Sensor faulty	Replace sensor Op. 1056B50
6	THERMOSTAT OPERATION CHECK	All OK	Problems met	Operation
	Bleed the cooling systemCheck that the thermostat is working properly	Continue to Step 7	Thermostat not working	Replace the thermostat Op. 1088C30
7	CHECK ON WATER PUMP	All OK	Problems met	Operation
	Check that the water pump is working properly	Continue to Step 8	Pump faulty	Replace the pump Op. 1088C10
8	COOLING SYSTEM LEAKAGE CHECK	All OK	Problems met	Operation
	Carry out the cooling system leak test Op. 0510C30	Continue to Step 11	No seal with visible leaks	Eliminate the leaks
	Carry out the cooling system leak test Op. 0510C30	Continue to Step 11	No seal without visible leaks	Continue to Step 9
9	HEAD HYDRAULIC LEAKAGE TEST	All OK	Problems met	Operation
	Check the hydraulic seal of the cylinder head Op. 1016E04	Continue to Step 10	Seal ineffective	Renew the seal, if necessary replace the head
10	MONOBLOCK HYDRAULIC SEAL TEST	All OK	Problems met	Operation
	CHECK ON BLOCK HYDRAULIC SEAL	Continue to Step 11	Seal ineffective	Renew the seal, if necessary replace the engine block
11	CHECK ON CORRECT OPERATION	All OK	Problems met	Operation
	Check that the fault is no longer present	End of diagnosis	The fault persists