184000757 - 0010T12 ENGINE OIL AND FILTER REPLACE

.

Engine oil is harmful to the skin: minimize contact of the oil with the skin; in case of contact wash with soap and water.

Position the vehicle on the ramp1. With the engine hot, remove the filler cap.2. Withdraw the oil level dipstick. 1. Undo the drain plug on the engine sump and drain the oil fully into a suitable container.

Be careful when removing the drain plug, as the oil could be very hot.

Do not disperse the oil into the environment, as indiscriminate dispersal of this product causes pollution.

Proceed with removal    Op. 7055B54 UNDER-ENGINE GUARD - R R1. Release and remove the engine oil filter using a suitable tool. Clean the drain plug and screw it on, with its seal, to the specified torque.

	Fastening	Component	Ø	Value(daNm)
-	-	ENGINE OIL DRAIN PLUG	M18	(Crankcase sump side) 1.8 ÷ 2.2

Lubricate the engine oil filter gasket with engine oil.Fit the engine oil filter and tighten it fully by hand.Refill the engine lubrication circuit using the recommended oil.

	Type	Component	Name	Qty.
-	Oli [l]	ENGINE OIL LEVEL CHECK AND TOP-UP	SELENIA TURBO DIESEL	4.4

The table shows the quantity for periodic replacement.

For the optimum operation of the engine in particularly harsh climatic conditions, use the recommended oil for the engine lubrication circuit.

	Type	Component	Name	Qty.
-	Oli [l]	ENGINE OIL LEVEL CHECK AND TOP-UP	SELENIA WR	4.4

The table shows the quantity for periodic replacement.

Check that the engine oil level on the dipstick is correct.

The oil level should be checked with the vehicle on flat ground.

Refit the filler cap, run the engine at idle speed for about 2 minutes, turn off the engine and wait a few minutes.Check the oil level and that there are no leaks.Proceed with refitting    Op. 7055B54 UNDER-ENGINE GUARD - R RRemove the car from the ramps.