1040B52 FUEL RETURN LINE - R R - Lancia - MUSA - eLearn

184000912 - 1040B52 FUEL RETURN LINE - R R

) Position the vehicle on the rampProceed with removal 1016A10 sound-proofing cover - r + r 1. Disconnect the push-on fitting on the front fuel return pipe, fuel return manifold pipe side, and release it from the fastenings in the engine compartment.

1. Release the protection and remove it.2. Loosen the adjustment nut for the handbrake cable by at least two or three turns to ensure that the cable is completely loosened.

Before loosening the nut, mark its original position.

1. Undo the nuts fixing the exhaust pipe between the precatalyzer and the catalyzer, catalytic converter side.2. Unscrew the bolt securing the flexible block bracket and lower the exhaust pipe.

1. Open the band retaining the handbrake cable.2. Undo the nuts (2a), remove the clip (2b) and remove the central heat shield (2c).

1. Remove the cap.2. Disconnect the handbrake cable from the rear brakes.

1. Place an appropriate stand under the fuel tank.2. Undo the fuel tank bracket retaining bolts.3. Lower the fuel tank as necessary to disconnect the push-on connector of the fuel return pipe, fuel pump side.4. Remove the fuel return pipe after releasing it from the fixings under the bodyshell.

Refitting ( Removing

) Refit the fuel return pipe in its seating and secure it with the clips under the bodyshell.Connect the push-on connector for the rear fuel return pipe, fuel pump side.Place the fuel tank back in its seating, then tighten the bolts securing the fuel tank brackets.Remove the stand from under the fuel tank.Connect the handbrake cable to the rear brakes.Place the plug back in position.Place the central heat shield back in its housing and secure it using the clip and nuts.Close the band securing the handbrake cables.Refit the exhaust pipe and tighten the flexible block bracket bolt.Tighten the nuts fixing the exhaust pipe between the precatalyzer and the catalyzer, catalyzer side, to the recommended torque.

	Fastening	Component	Ø	Value(daNm)
-	Nut	PRE-CAT CONVERTOR/CAT CONVERTOR PIPE	M8	(Catalyitic preconverter side) 2.3 ÷ 2.8

Proceed with refitting Op. 3380A04 HANDBRAKE - CHECK TRAVELConnect the push-on fitting for the fuel return pipe to the tank, fuel return manifold pipe side, and secure in the engine compartment using the collars.Proceed with refittingRemove the car from the ramps. 1016A10 sound-proofing cover - r + r