D10 ENGINE IDLE IRREGULAR - Lancia - MUSA - eLearn

184000417 - D10 ENGINE IDLE IRREGULAR

The engine is not running smoothly when idling; in particular, it does not maintain a constant, regular value as the load varies (e.g. when electrical devices are switched on)

0	PRELIMINARY CHECKS	All OK	Problems met	Operation
		Results of the tests
	Preliminarily check: the state of the spark plugs and leads; the condition of the air filter the condition of the air intake circuit	Continue to Step 1	Spark plugs dirty or defective	Replace the filter element Op. 5510D10
			Leads defective	Replace the spark plug leads Op. 5510D14
			Air filter blocked	Replace the filter element Op. 5510D10
			Fault in air intake circuit	Restore the correct operation of the intake circuit
1	CHECK WITH DIAGNOSTIC EQUIPMENT	All OK	Problems met	Operation
	Connect the diagnostic equipment (Examiner or other instruments) to the diagnostic socket. Check: that there are no faults in the engine management control unit; plausibility of all the parameters	Continue to Step 2	'Supply system' error detected	Coolant leaks detectedSee table Z50
			Another error dectected in the control unit	Continue following the instructions for the diagnostic equipment
			Inconsistent parameter	Continue following the instructions for the diagnostic equipment
2	IDLE ACTUATOR CHECK	All OK	Problems met	Operation
	Check that the system carries out the correct idle learning procedure	Continue to Step 3	Irregular idling	Carry out the idle learning procedure correctly
3	PETROL VAPOUR RECOVERY SYSTEM CHECK	All OK	Problems met	Operation
	Check the condition and seal of the petrol vapour recovery pipes	Continue to Step 4	Air seepage	Restore the correct seal
		Continue to Step 4	Pipe from canister to solenoid broken	Replace the pipe
4	PETROL VAPOUR RECOVERY SOLENOID VALVE CHECK	All OK	Problems met	Operation
	Carry out active diagnosis of solenoid	Continue to Step 6	Solenoid not working	Continue to Step 5
5	SOLENOID VALVE ELECTRICAL CIRCUIT CHECK	All OK	Problems met	Operation
	Check supply and earth of petrol vapour recovery solenoid	Continue to Step 6	Solenoid valve faulty	Replace the solenoid valve Op. 1080E28
6	BRAKE SERVO AND PIPE CHECK	All OK	Problems met	Operation
	Check condition of: brake servo vacuum pipes; brake servo See Test 3330DA Check operation of brake servo vacuum circuit and vacuum unit	Continue to Step 7	Brake servo pipe defective	Replace the pipe
		Continue to Step 7	Brake servo defective	Replace the brake servo/pump assembly Op. 3330D02
7	CHECK ON FUEL PRESSURE	All OK	Problems met	Operation
	Check the fuel supply pressure Op. 0510C10	Continue to Step 8	Insufficient fuel pressure: pipe obstructed	Eliminate the blockage; if necessary replace the pipe
			Low fuel pressure: clogged filter	Replace the pump assembly Op. 3330D02
			Insufficient fuel pressure: regulator out of calibration	Replace the pump assembly Op. 3330D02
			Low fuel pressure: defective pump	Replace the pump assembly Op. 3330D02
8	CHECK ON TIMING	All OK	Problems met	Operation
	Check that the timing is correct Op. 0510A20	Continue to Step 9	Timing not correct	Restore the correct timing
9	CHECK ON CORRECT OPERATION	All OK	Problems met	Operation
	Check that the fault is no longer present	End of diagnosis	Fault persists: control unit faulty	Replace control unit Op. 1056B82