P30 DOORS / BOOT OPEN BUZZER NOT PRESENT WITH CAR IN MOTION - Lancia - MUSA - eLearn

184000573 - P30 DOORS / BOOT OPEN BUZZER NOT PRESENT WITH CAR IN MOTION

With the vehicle moving, the accidental opening of one of the doors or the boot is not indicated by the buzzer.

The instrument panel node acquires from the network the signal indicating the status of the door switches or boot and the vehicle speed. If a door or the boot are opened and the vehicle speed is over 4 km/h, an acoustic signal is emitted.

This function can be enabled/disabled via the MODE +/- keys on the controls switch panel unit. Make sure that the function has not been disabled incorrectly by the user

0	PRELIMINARY CHECKS	All OK	Problems met	Operation
		Results of the tests
	Connect the Examiner diagnostic instrument and check, in the active diagnosis environment, that the buzzer is working properly	Continue to Step 1	The buzzer is not working	Replace the Instrument Panel Node Op. 5560B11
1	CHECKING WITH DIAGNOSTIC EQUIPMENT	All OK	Problems met	Operation
	Connect an Examiner and check the door/boot status has been correctly downloaded while in parameter mode	Continue to Step 4	Malfunction in acquisition of door switch status	Continue to Step 2
		Continue to Step 4	Malfunction in acquisition of boot open switch status	Continue to Step 3
2	ELECTRICAL CONNECTIONS CHECK	All OK	Problems met	Operation
	Check the electrical connections between the doors and Body Computer See E2510 COURTESY LIGHTS Also check that the door switches are not faulty	Continue to Step 4	Connections faulty	Restore the correct connections See E2510 COURTESY LIGHTS
			Front door switch faulty	Replace the door open motor Op. 7005N21
			Rear door switch faulty	Replace the door open motor Op. 7010N21
3	ELECTRICAL CONNECTIONS CHECK	All OK	Problems met	Operation
	Check the electrical connections between boot open switch and Body Computer See E2520 GLOVE COMPARTMENT LIGHT - LUGGAGE COMPARTMENT LIGHT - SUN VISOR LIGHT Also check that the boot open switch is not faulty	Continue to Step 4	Connections faulty	Restore the correct connections See E2520 GLOVE COMPARTMENT LIGHT - LUGGAGE COMPARTMENT LIGHT - SUN VISOR LIGHT
		Continue to Step 4	Boot open switch faulty	Replace the boot outer handle Op. 7015B30
4	CHECKING WITH DIAGNOSTIC EQUIPMENT	All OK	Problems met	Operation
	Connect the Examiner and check on the body computer node: that there are no errors on the C-CAN line; that there are no errors on the C-CAN line;	Continue to Step 5	Error in the C-CAN line.	Continue following the instructions for the diagnostic equipment
		Continue to Step 5	Error found in speedometer signal.	Continue according to the instructions See table K03 SPEEDOMETER NOT WORKING
5	CHECKING WITH DIAGNOSTIC EQUIPMENT	All OK	Problems met	Operation
	Keep the Examiner connected and check the body computer node for: errors in the B-CAN line; errors in the speedometer signal.	Continue to Step 6	Error found in the B-CAN line.	Continue following the instructions for the diagnostic equipment
		Continue to Step 6	Error found in speedometer signal.	Continue according to the instructions See table K03 SPEEDOMETER NOT WORKING
6	ELECTRICAL CONNECTIONS CHECK	All OK	Problems met	Operation
	Check the electrical connections between the instrument panel and Body Computer See E4010 INSTRUMENT PANEL	Continue to Step 7	Connections faulty	Restore the correct connections See E4010 INSTRUMENT PANEL
7	CHECK ON CORRECT OPERATION	All OK	Problems met	Operation
	Check that the fault is no longer present.	End of diagnosis	Fault persists	Replace the Body Computer Op. 5505A32