Z75 STEERING ANGLE SENSOR ERROR - Lancia - MUSA - eLearn

184000625 - Z75 STEERING ANGLE SENSOR ERROR

The diagnostic equipment signals the following errors: "C1117 - Steering Angle Sensor" and "C1517 - Steering Angle sensor: compensation error"

These errors are signalled if there is a short circuit at the CAN (supply or earth), if it is damaged or not correctly fitted. Error C1117 can also occur after the battery has been disconnected and reconnected or as a result of difficulties in starting because the information coming from the electric steering is not felt to be valid by the NFR.

0	PRELIMINARY CHECKS	All OK	Problems encountered	Operation
		Results of the tests
	Check whether the battery has been disconnected and reconnected in the workshop or if the VDC warning light has come on after difficulties in starting	Move on to Step 2	The VDC warning light has remained on after the battery has been disconnected and reconnected	Move on to Step 1
		Move on to Step 2	The VDC warning light has remained on after difficulties in starting	Move on to Step 1
1	VALIDATION OF STEERING ANGLE INFORMATION	All OK	Problems encountered	Operation
	Carry out a key on and, after the warning light check, turn the steering wheel a few degrees around the zero (wheels straight) position. Then carry out a key off/key on	Move on to Step 6	The VDC warning light does not go out	Move on to Step 2
2	CHECKS USING DIAGNOSTIC EQUIPMENT	All OK	Problems encountered	Operation
	Connect the diagnostic equipment and check the operation of the steering angle sensor.To do this enter the PARAMETERS ambient and display the STEERING ANGLE parameter: the values should decrease when the steering wheel is turned in a clockwise direction (to the right) and increase when it is turned in the opposite direction	Move on to Step 6	Failed or irregular operation of the steering angle sensor: the steering angle value is always zero	Move on to Step 3
3	WHEEL TOE IN CHECK	All OK	Problems encountered	Operation
	Check the toe in of the front and rear wheels	Move on to Step 4	The vehicle has lost its toe in	Restore the toe in and move on to Step 6
4	CAN CHECK	All OK	Problems encountered	Operation
	Check that the continuity is correct: for the C CAN, by carrying out Test 5505OA See Test 5505 INSTRUMENT/GUAGE ELECTRICAL WIRING for the ABS control unit impedance for the Body Computer impedance	Move on to Step 6	Resistance for defective ABS control unit does not conform	Replace ABS control unit Op. 3340A12 ABS HYDRAULIC AND ELECTRONIC CONTROL UNIT
			C CAN connections faulty	Restore correct connection and move on to Step 6
			Resistance does not conform for defective Body Computer	Replace Body Computer Op. 5505A32 BODY COMPUTER - R R
5	ELECTRICAL CHECKS	All OK	Problems encountered	Operation
	Check the continuity of the wiring and the insulation of the line from the NFR to the NGE E7023 ESP	Move on to Step 6	Faults in the connection	Restore the correct connection
6	CHECK ON CORRECT OPERATION	All OK	Problems encountered	Operation
	Delete the errors using the diagnostic equipment.Carry out a road test to ensure that the control unit checks whether there are any errors still present. See Test 3350EB STEERING ANGLE SENSOR OPERATION CHECKReturn to the workshop and check that the fault is no longer present using the diagnostic equipment	End of diagnosis	The fault persists	Move on to Step 0