184000636 - Z88 LONGITUDINAL ACCELERATION SENSOR ERROR

Ошибка в шаблоне. В ближайшее время мы ее исправим. (Error in Templaite)

This error is signalled if the sensor output voltage is below 0.3 V or above 4.7 V or if the slewing sensor supply voltage is more than 5.3 V or less than 4.7 V or if the value sent by the sensor is not plausible. This means that there is an open circuit or short circuit (positive or earth) for the sensor or the wiring, that the sensor is mechanically damaged or that the reading circuit is damaged.

	Results of the tests
1	ELECTRICAL CHECKS	All OK	Problems encountered	Operation
	Check that the longitudinal acceleration sensor supply voltage is correct.    See E7023 ESPCheck that the longitudinal acceleration sensor output voltage (longitudinal acceleration signal) is correct: see Test 3350ED.    See Test 3350E VEHICLE DIRECTION CONTROL SYSTEM VDC	Move on to Step 3	Voltage not correct at accelerometer	Move on to Step 2
2	ELECTRICAL CONNECTION CHECK	All OK	Problems encountered	Operation
	Check that the electrical connections between the acceleration sensor and the ABS control unit are correct    See E7023 ESP    See Test 3350E VEHICLE DIRECTION CONTROL SYSTEM VDC	Move on to Step 3	Wiring faulty	Renew the wiring and move on to Step 3
			Sensor not correctly fastened	Restore the correct fastening for the sensor and move on to Step 3
3	CHECK ON CORRECT OPERATION	All OK	Problems encountered	Operation
	Delete the errors using the diagnostic equipment. Carry out the road test    See Test 3350EA ESP SYSTEM ACTUATION CHECKto ensure that the control unit checks whether the errors are still present. Return to the workshop and check that the fault is no longer present using the diagnostic equipment	End of diagnosis	The fault persists	Move on to Step 1