184000637 - Z89 CLUTCH SWITCH ERROR

Ошибка в шаблоне. В ближайшее время мы ее исправим. (Error in Templaite)

This error is signalled if the clutch switch is not working properly. The clutch switch is used for the operation of the Hill Holder.

	Results of the tests
1	CLUTCH PEDAL SWITCH OPERATION CHECK	All OK	Problems encountered	Operation
	Connect the Examiner, enter into the fault diagnosis in the "PARAMETERS" ambient (Engine management) and check the "CLUTCH PEDAL STATUS" parameter. Press the clutch pedal and read "PRESSED". Release the clutch pedal and read "RELEASED"	Move on to Step 4	Incorrect reading	Replace the sensor. Move on to Step 2
2	CLUTCH SWITCH CHECK	All OK	Problems encountered	Operation
	Detach the connector for the switch and check its operation	Move on to Step 3	The switch is not working properly	Replace the switch. Move on to Step 4
3	ELECTRICAL CONNECTION CHECK	All OK	Problems encountered	Operation
	Check the electrical continuity between the clutch switch and the engine management control unit.	Move on to Step 4	Electrical continuity failure between the switch and the engine management control unit	Restore the connection. Move on to Step 4
4	CHECK ON CORRECT OPERATION	All OK	Problems encountered	Operation
	Road test the vehicle to check that the system is working properly. Return to the workshop and check that the fault is no longer present using the diagnostic equipment	End of diagnosis	-	-