Ошибка в шаблоне. В ближайшее время мы ее исправим. (Error in Templaite)
| |
| Results of the tests |
| 1 | SUPPLY CHECK | All OK | Problems encountered | Operation |
|---|
| Check the electric steering power supply See E7045 ELECTRIC STEERING | Move on to Step 2 | Electric steering power supply missing | Restore the power supply and move on to Step 6 |
| 2 | CHECK USING DIAGNOSTIC EQUIPMENT | All OK | Problems encountered | Operation |
|---|
| Carry out the fault diagnosis using the Examiner for the CAN control units to check that there are no errors at the NGE | Move on to Step 3 | Presence of errors at CAN control units | Solve the problem for the control unit where the error is present. |
| Errors present for the electric steering | Solve the problem for the electric steering |
| 3 | CAN IMPEDANCE CHECK | All OK | Problems encountered | Operation |
|---|
| Check the correct CAN impedance by carrying out Test 5505OA, See Test 5505 INSTRUMENT/GUAGE ELECTRICAL WIRING | Move on to Step 6 | ABS control unit faulty through impedance that does not conform | Replace the ABS control unit Op. 3340A12 ABS HYDRAULIC AND ELECTRONIC CONTROL UNIT |
| CAN faulty | Restore CAN |
| 4 | CAN COMMUNICATION CHECK | All OK | Problems encountered | Operation |
|---|
| Check that error U1701 (NCM missing) is not also present in the brake control unit with the counter equal to or close to the reading for U1717 | Move on to Step 5 | Error U1701 also present | Proceed as instructed in the See table Z80 ENGINE CAN MESSAGE ERROR |
| 5 | CAN WIRING CHECK | All OK | Problems encountered | Operation |
|---|
| Check that the CAN connection between the NCM and NGE is correct See E7020 ABS | Move on to Step 6 | Wiring defective | Restore the correct connection |
| 6 | CHECK ON CORRECT OPERATION | All OK | Problems encountered | Operation |
|---|
| Delete the errors using the diagnostic equipment. Carry out the road test See Test 3350EA ESP SYSTEM ACTUATION CHECKto ensure that the control unit checks whether the errors are still present. Return to the workshop and check that the fault is no longer present using the diagnostic equipment | End of diagnosis | - | - |
