2891491 - 1043A04 gpl system and pipes check for leaks (GPOWER)

After any maintenance or replacement operation which has involved adjusting the connectors or moving the pressurized components, a search for LPG leaks should be carried out proceeding as described below.Reconnect the 7.5A protective fuse for the solenoid valves and the LPG pump, disconnected when the LPG pipes were drained.Road test the vehicle by driving for about 5-10 km in the LPG operating mode.Return the vehicle to the workshop and place it on a lift.1. Using an electronic detector, search for any escaping gas checking each component and each individual pipe in the LPG system along the bodyshell and in the engine compartment.If no leaks are found using the electronic detector, then the vehicle has passed the test and may leave the workshop.2. If this is not the case, identify the section of the system where the leak is coming from using the electronic detector, then apply the special foam to the components in order to identify the exact point where the gas is escaping.Repair the component involved, checking the cause of the leak (connectors not properly tightened, seals not replaced, defects in the part).Road test the vehicle again and repeat the procedure described for checking for leaks until the problem is completely resolved.