7055A62 MOULDING ON ONE PILLAR, L/H OR R/H - R+R - Fiat - MULTIPLA - eLearn

2892261 - 7055A62 MOULDING ON ONE PILLAR, L/H OR R/H - R+R

) CENTRE PILLAR:1. Open the doors and undo the bolt.2. Remove the moulding (2a) moving it downwards to release the retainer (2b) from the nut (2c).

FRONT PILLAR:1. Open the front door and, using a plastic blade, remove the moulding (1a) releasing the retainers (1b) and the adhesive tape (1c).

Refitting ( Removing

) FRONT PILLARCheck that the new moulding is not damaged.1. Clean the area (1a) of the bodyshell involved in the refitting of the adhesive tape (1b) for the moulding, removing the residual adhesive, then degrease using heptane.2. Remove the protective film (2a) for the adhesive tape than place the moulding (2b) in position attaching the retainers (2c). Press on top of the adhesive (1b) to stick it to the bodyshell.

This sticking operation should be carried out at a temperature above 20°C.

CENTRE PILLARCheck that the moulding is not damaged.Place the moulding on the reatiner nut and attach it.

If necessary, align the moulding with the doors, adjusting the nut.

Tighten the bolt and close the doors.