2888442 - P11 CENTRAL LOCKING / NOT WORKING WITH REMOTE CONTROL
When the central locking is operated using the remote control the doors do not open / close at all (on the other hand, they open perfectly using the key)| Results of the tests | ||||
| 0 | PRELIMINARY CHECKS | All OK | Problems met | Operation |
|---|---|---|---|---|
| Check the charge of the remote control battery incorporated in the key | Continue to Step 1 | Remote control battery charge low | Replace the remote control battery | |
| 1 | CHECK CENTRAL LOCKING ELECTRICAL CIRCUIT | All OK | Problems met | Operation |
Check, in order:
| Continue to Step 2 | Connections not correct | Restore the connections | |
| Component defective | Replace the component involved (if a fuse is involved, search for the cause of the problem) | |||
| 2 | CHECK WITH DIAGNOSTIC EQUIPMENT | All OK | Problems met | Operation |
| Connect the diagnostic equipment (Examiner or other instruments) to the diagnostic socketCheck that there are no faults in the remote control receiver. | Continue to Step 3 | Error detected in the receiver | Continue according to the instructions for the diagnostic equipment | |
| Receiver not working | Replace the receiver Op. 5580E30 | |||
| Dialogue failure for diagnostic equipment between the control unit and the receiver | Restore the connecting serial line between the remote control receiver and the diagnostic connector ( See E3040 CENTRAL LOCKING ) | |||
| 3 | CHECKING CORRECT OPERATION | All OK | Problems met | Operation |
| Check that the fault is no longer present | End of diagnosis | Fault persists | Search for the fault starting from another symptom' | |