1028H20 PISTON WITH CONNECTING ROD - R R - Fiat - MULTIPLA - eLearn - 4CarData

2891217 - 1028H20 piston with connecting rod - r r

Removing ( Refitting

) Place the car on a ramp.Disconnect the battery's negative terminal. - 1088D10 lower sleeve for coolant outlet from radiator - r + r - 1088D14 upper sleeve for coolant inlet to radiator - r + r - 1048A10 air cleaner filtering element - replace - 1072B50 sleeves connecting air capacity box to inlet manifold is - r+r - 1072B14 inlet manifold - r+r and replace seal with air conveyor/box removed - 1032B10 toothed timing belt - r + r for timing adjustment or replacement - 1032B40 toothed-driven pulley (one) - r + r with timing belt removed- 1032D34 timing system guard assemblies - r + r - 1056B51 cam angle sensor r + r - 1072C44 exhaust manifold heat shield on bulkhead - r+r - 1016B22 lh cylinder head extension - r r with timing belt removed - replace gasket - 1016B26 rh cylinder head extension -r r with timing belt removed -replace gasket - 1016C10 cylinder head - r + r and replace gasket - 1020A20 crank case oil sump - r + r clean seals for sealant applicationRotate the crankshaft until the piston concerned is at B.D.C.1. Undo bolts (1a) and remove connecting rod cap (1b) together with lower bearing half (1c).

Lower the lift.1. Remove the connecting rod - piston assembly (1a) together with the upper bearing half (1b).

Refitting ( Removing

) 1. Fit connecting rod - piston assembly (1a) together with upper bearing half (1b) using installer (1c).

Raise the ramp.Fit the connecting rod cap together with the lower bearing half.Tighten the connecting rod cap bolts to torque.

	Fastening	Component	Ø	Value(daNm)
-	Nut	CONNECTING ROD CAP FASTENERS	M9	5.1

- 1020A20 crank case oil sump - r + r clean seals for sealant application - 1016C10 cylinder head - r + r and replace gasket - 1072C44 exhaust manifold heat shield on bulkhead - r+r- 1056B51 cam angle sensor r + r - 1056B51 cam angle sensor r + r - 1032D34 timing system guard assemblies - r + r - 1032B40 toothed-driven pulley (one) - r + r with timing belt removed - 1032B10 toothed timing belt - r + r for timing adjustment or replacement - 1072B14 inlet manifold - r+r and replace seal with air conveyor/box removed - 1072B50 sleeves connecting air capacity box to inlet manifold is - r+r - 1088D10 lower sleeve for coolant outlet from radiator - r + r - 1088D14 upper sleeve for coolant inlet to radiator - r + r - 1048A10 air cleaner filtering element - replaceConnect the battery's negative terminal.Remove the vehicle from the ramp.