2891270 - 1056B90 system cable bundle - r + r

Removing ( Refitting ) Place the car on a ramp.Open the bonnet lid.With the ignition key in the OFF position, disconnect the battery negative terminal. - 1088E10  radiator cooling fan - r + rRaise the car.1. Disconnect the electrical connections (1a), (1b), (1c), (1d) and (1e).

	Name	Connector
1a	Detonation sensor	K50

	Name	Connector
1b	Brake fluid level sensor (switch)	K30

	Name	Connector
1c	Timing sensor	K47

	Name	Connector
1d	RPM sensor	K46

	Name	Connector
1e	Alternator	A10

2. Undo nut (2a) and disconnect the earth cable from starter motor (2b).3. Open the wiring channel and take out the injection system wiring.4. Disconnect electrical connections (4a), (4b), (4c), (4d), (4e), (4f), (4g), (4h) and (4i).

	Name	Connector
4a	Injector	N70

	Name	Connector
4b	Ignition coil	A30

	Name	Connector
4c	Engine coolant temperature sensor	K45

	Name	Connector
4d	Speedometer sensor	K84

	Name	Connector
4e	Engine management ECU	M10A

	Name	Connector
4f	Front/engine junction	D4

	Name	Connector
4g	Throttle position sensor	K56

	Name	Connector
4h	Idle actuator	N74

	Name	Connector
4i	Integrated air temperature sensor	K43

5. Release the wiring from the retaining collars and remove it. Refitting ( Removing ) Position the engine wiring in the engine bay.Connect the electrical connections.

	Name	Connector
-	Integrated air temperature sensor	K43

	Name	Connector
-	Idle actuator	N74

	Name	Connector
-	Throttle position sensor	K56

	Name	Connector
-	Front/engine junction	D4

	Name	Connector
-	Engine management ECU	M10

	Name	Connector
-	Speedometer sensor	K84

	Name	Connector
-	Engine coolant temperature sensor	K45

	Name	Connector
-	Ignition coil	A30

	Name	Connector
-	Injector	N70

Close the wiring channel after arranging the injection system wiring.Connect the earth lead to the starter motor.Connect the electrical connections to the front part of the engine.

	Name	Connector
-	Detonation sensor	K50

	Name	Connector
-	Brake fluid level sensor (switch)	K30

	Name	Connector
-	Timing sensor	K47

	Name	Connector
-	RPM sensor	K46

	Name	Connector
-	Alternator	A10

Lower the vehicle. - 1088E10  radiator cooling fan - r + rWith the ignition key in stop position, connect the battery negative terminal.Close the bonnet lid.Remove the vehicle from the ramp.