5580C12 CLOCK SPRING FOR AIR BAG MODULE ON STEERING WHEEL R R - Fiat - MULTIPLA - eLearn

2891970 - 5580C12 clock spring for air bag module on steering wheel r r

) Place the steering wheel in the centred position with the wheels straight. - 5580C18 air bag module - r+rClosely observe the safety regulations established for this operation. - 4110A11 steering wheel - r+r for replacement or check for versions with air bag - 7040A26 steering column trim - r+r1. Disconnect the electrical connection.

	Name	Connector
1	Clock spring on steering wheel	Q10

2. Undo the bolts.3. Remove the clock spring.The clock spring is fitted with a device which automatically stops its rotation when it is removed from the steering wheel. Avoid forcing its rotation.

1. If the clock spring is reused it is advisable to secure the two plates with a band to prevent accidental rotations.

Refitting ( Removing

) Check that the wheels are straight.The parts supplied as spares are for fitting in a centred position.

If, for any reason, the upper plate for the clock spring should rotate in relation to the lower one in such a way that the relative position is no longer known, then the clock spring must be replaced.

Place the clock spring in its housing (if it is being resued, remove the band fitted previously).Tighten the bolts.Reconnect the electrical connection.1. If the clock spring is being replaced with a new one, remove the safety tab.

- 7040A26 steering column trim - r+r - 4110A11 steering wheel - r+r for replacement or check for versions with air bag - 5580C18 air bag module - r+rConnect the battery.Test the operation of the horns.Check the operation of the system using the Examiner or the other diagnostic equipment.