2891561 - 2710A20 wheel end constant velocity joint (one), l/h or r/h - r + r with drive shaft removed - includes boot replacement
Removing
(
Refitting
)
Place the drive shaft in a vice.1. Remove the clip and push back the gaiter.2. Remove the constant velocity joint from the drive shaft.3. Clean the grease off the inside of the bearing housing, and,
using tools (3a) and (3b) while at the same time using pliers on
the circlip inside the joint, remove the ring (3c) fixing the constant
velocity joint bearing.4. Then remove the protective gaiter (4a), removing its retaining
clip (4b). | Name | Country |
|---|---|---|
| 3a | Adaptor | 1.860.889.000 |
| Name | Country |
|---|---|---|
| 3b | Counter weight | 1.847.017.001 |
Refitting
(
Removing
)
Check that the drive shaft is not deformed
or out of true in the area where the joint fits, and that the area
in contact with the seal is not worn.Fit the new protective gaiter on the drive
shaft.Fit the bearing on the drive shaft.Fill the protective gaiter and bearing
with TUTELA MRM2 grease.Position the constant velocity joint and
fit it on the bearing with slight pressure.Secure the protective gaiter to the joint,
using two new clips.