2710A24 DIFFERENTIAL END CONSTANT VELOCITY JOINT (ONE) L/H OR R/H - R + R WITH DRIVE SHAFT REMOVED - INCLUDES BOOT REPLACEMENT - Fiat - MULTIPLA - eLearn

2891562 - 2710A24 differential end constant velocity joint (one) l/h or r/h - r + r with drive shaft removed - includes boot replacement

) Place the drive shaft in a vice.1. Remove the circlip (1a) and withdraw the tripod joint from the drive shaft (1b).2. Remove the clip (2a) and remove the gaiter (2b).

1. If necessary, remove the fluid-tight bearing from the drive shaft, using the universal puller.

Refitting ( Removing

) Fit the new protective gaiter on the drive shaft.1. If the left fluid-tight bearing has been removed, it must be refitted in accordance with the specified dimensions.Dimension for fitting left drive shaft fluid-tight roller bearing.

	Measurement		Value
1	Fitting of left driveshaft roller bearing (mm)		143.8

Dimension for fitting left drive shaft ball bearing.

	Measurement		Value
1	Fitting of left driveshaft ball bearing (mm)		142.7

2. If the right fluid-tight bearing has been removed, it must be refitted in accordance with the specified dimensions.Dimension for fitting right drive shaft fluid-tight roller bearing.

	Measurement		Value
2	Fitting of right driveshaft roller bearing (mm)		108.8

Dimension for fitting right drive shaft ball bearing.

	Measurement		Value
2	Fitting of right driveshaft ball bearing (mm)		107.7

1. Using the tool (1a), fit the fluid-tight bearing (1b) on the drive shaft in accordance with the above dimensions.

	Name	Country
1a	Drift	1.870.448.000

Check that the drive shaft is not deformed or out of true in the area where the joint fits, and that the area in contact with the seal is not worn.Fit the tripod joint on the drive shaft.Fill the protective gaiter and bearing with TUTELA MRM2 grease.