2892312 - 7210B35 R.R. REAR OUTER WHEEL ARCH

Removing ( Refitting )  - 7210E52  R.R. REAR WINGCheck if any of the connected parts are deformed by checking body alignment dimensions. Use appropriate measurement tools (reference rigs, templates or gauges).Straighten the body if necessary. 1. Use a chamfering machine to remove the weld spots.2. Drill out the weld spots shown in the figure.3. Use a chisel and mallet to remove the outer wheel arch half. Straighten the panel edges using a hammer and profiled stake.Use a grinding wheel to remove the spot weld residues.1. Make holes as shown in the figure.2. Apply the electroweldable paint finish. Use a rotary brush to remove the corrosion-proofing from around the inner and outer edge of the part.1. Drill holes at the points shown in the figure.2. Apply electroweldable paint finish to the panel edges indicated. Refitting ( Removing ) 1. Position the part on the car and secure using self-locking grippers.2. Fit the rear wing.Fit the door seal and door.Close the door.Check the alignment and ensure the surrounding gaps are even.Remove the parts fitted previously. 1. Use a spot welder to weld the areas shown in the figure.2. Use a MIG welder to fill the holes made previously. Correct any deformations in the panel using a profiled stake and mallet.1. Use a grinding wheel to level the weld and remove. Apply rust-proofing to newly-welded areas.1. Seal the areas indicated in the figure.Apply paint.2. Apply wax oil protection through the hole indicated. Refit fouling parts. - 7210E52  R.R. REAR WING