2892369 - 1043AA Check operation of LPG pump (GPOWER)

The operating test consists of a test on the total absorption by the following loads:LPG pump.Solenoid positioned on LPG cylinder.Solenoid positioned on pressure regulator.Proceed as follows:Measure the battery voltage with all the loads switched off, and make sure that the no-load voltage is not less than 12.8 V; if it is, recharge the battery.Turn the ignition key to the OFF position.Fit an ammeter lead to the battery's negative cable.Disconnect the relay.

	Name	Connector
-	Methane/LPG relay feed	J26

Bridge terminals 30 and 87 with a piece of cable containing a 7.5 A fuse. Check that the total absorption of the supplied loads is about 5 A.