7050A92 TELESCOPIC STRUT FOR LIFTING REAR SEAT, ONE LEFT OR RIGHT - R.R. - Fiat - MULTIPLA - eLearn

2892247 - 7050A92 TELESCOPIC STRUT for lifting rear seat, one left or right - R.R.

) - 7050A96 rear seat guard (one) - r r (right and left) 1. Disconnect the squab control cable (1a) from the retainers (1b).

1. Undo the four bolts securing the cushion to the frame.2. Disengage the cushion cover anchor section.3. Remove the cushion assembly.

1. Open the squab control lever and, using a screwdriver, disengage the retainers (1a) then remove the lever trim (1b).2. Using a screwdriver, disengage the retainers (2a) and remove the moulding (2b).

1. Remove the cover surround.Start from one lateral end.2. Remove the metal part of the seat.

1. Cut the retainers securing the cover to the padding.2. Remove the cover from the padding.

Refitting ( Removing

) Check that the cushion cover is intact and shows no signs of damage.Secure the cover to the padding using the retaining rings.Fit the metal part of the seat and fit the cover surround.Fit the squab control moulding and engage the retainers.Fit the lever trim and engage the retainers.Refit the cushion assembly to the frame.Refit the cushion cover anchor section.Mould the cover onto the padding.Tighten the four bolts securing the cushion to the frame.Connect the squab control cable to the retainers. - 7050A96 rear seat guard (one) - r r (right and left)