2891561 - 2710A20 wheel end constant velocity joint (one), l/h or r/h - r + r with drive shaft removed - includes boot replacement

Removing ( Refitting ) Place the drive shaft in a vice.1. Remove the clip and push back the gaiter.2. Remove the constant velocity joint from the drive shaft.3. Clean the grease off the inside of the bearing housing, and, using tools (3a) and (3b) while at the same time using pliers on the retaining ring inside the joint, remove the ring (3c) fixing the constant velocity joint bearing.4. Then remove the protective gaiter (4a), removing the clip (4b).

NameCountry
3aAdaptor1.860.889.000

NameCountry
3bCounter weight1.847.017.001
Refitting ( Removing ) Check that the drive shaft is not deformed or out of true in the area where the joint fits, and that the area in contact with the seal is not worn.Fit the new protective gaiter on the drive shaft.Fit the gearing on the drive shaft.Fill the protective gaiter and bearing with TUTELA MRM2 grease.Position the constant velocity joint and press it gently onto the bearing.Secure the protective gaiter to the joint, using two new clips.