1040A10 FUEL TANK - R + R AND DECANT FUEL - Fiat - MULTIPLA - eLearn

2891378 - 1040A10 fuel tank - r + r and decant fuel

) With the ignition key in the OFF position, disconnect the battery negative terminal.

	Name	Connector
-	Battery	A1

Place the car on a ramp.Drain the fuel from the tank using suitable equipment and appropriate protection to meet current safety requirements. - 7050A90 rear seat (one) - r re - repair with seat removed - 7040L14 panel brackets (1) covering seat attachments to passenger compartment floor - r r (Carry out this operation on the central and right rear seats) 1. Lift the pre-cut section of the floor covering to gain access to the fuel pump flap.2. Unscrew retaining bolts (2a) and remove protective cover (2b).3. Disconnect the electrical connection from the level gauge.

	Name	Connector
3	Fuel pump and sender unit	N40

4. Disconnect the fuel outlet and return lines from quick-release fittings (4a) and (4b).

Raise the car.1. Undo the retaining bolts.2. Remove the plastic fuel filler pipe protection.

1. Open collars (1a) and disconnect fuel filler pipe (1b) and pipe (1c).

1. Position a stand beneath the tank to support it during removal.2. Undo the tank bracket retaining bolts.3. Lower the hydraulic jack and remove the hydraulic tank.

Refitting ( Removing

) Position the fuel tank on the stand.Raise the tank into it fits into its seat.Tighten the bolts securing the tank to the body.Tighten the tank bolts to torque.

	Fastening	Component	Ø	Value(daNm)
-	Bolt	FUEL TANK	M8	3.5

Remove the tank stand.Use new colllars to connect the fuel filler pipe.Fit the plastic filler pipe protection.Lower the vehicle.Connect the fuel inlet and outlet pipe quick-release fittings.Connect the electrical connection to the electric pump and level gauge.Tighten the fuel pump protective cover retaining bolts.Refit the floor covering. - 7040L14 panel brackets (1) covering seat attachments to passenger compartment floor - r r - 7050A95 mount (one) fitting rear seat to floor - r r- 7050A10 rear seat - r+r perhaps A90 Remove the vehicle from the ramp.Use the correct equipment and appropriate protection as required by current safety legislation to fill the vehicle with the recommended fuel.With the ignition key in OFF position, connect the battery negative terminal.

	Name	Connector
-	Battery	A1