3340B76 RIGID PIPE(ONE), LH OR RH, TO REAR BRAKE CYLINDER - R R - Fiat - MULTIPLA - eLearn

2891654 - 3340B76 rigid pipe(one), lh or rh, to rear brake cylinder - r r

) Place the car on a ramp.1. Use wrench (1a) to disconnect rear brake pipe fitting (1b) from the cylinder.2. Unscrew fitting (2a) and remove rigid pipe (2b) to the rear cylinder.

	Name	Country
1a	Box wrench for brake fittings	1.856.132.000

Refitting ( Removing

) Fit the rigid pipe, tightening the front fitting.Use the appropriate tool to tighten the fitting for the rear brake pipe from the cylinder - 3330A18 front or rear hydraulic brake system - bleed .

Removing ( Refitting

) Position the vehicle on the ramp.Disconnect the battery negative terminal.

	Name	Connector
-	Battery	A1

- 4450B11 WHEEL (one) rear - R.R.1. Using the special tool, undo the connector on the rigid rear brake pipe (1a) from the flexible connector (1b).2. Remove the pipe retaining clip.

	Name	Country
-	Box wrench for brake fittings	1.856.132.000

1. Using the special tool, disconnect the connector for the rigid pipe (1a) and remove the retaining clip (1b). 2. Disconnect the rigid pipe and remove it from the vehicle.

Refitting ( Removing

) Position the rigid pipe and fasten it using the clip.Using the special tool, connect the connector for the rigid pipe to the rear brake caliper flexible pipe and tighten it to the recommended torque.

	Name	Country
-	Box wrench for brake fittings	1.856.132.000

	Fastening	Component	Ø	Value(daNm)
-	Connector	RIGID PIPE REAR CYLINDERS (ABS)	M10 x 1	1.6

Using the special tool, connect the connector for the rigid rear brake pipe to the section of the flexible pipe and tighten it to the recommended torque.Fit the pipe retaining clip.

	Name	Country
-	Box wrench for brake fittings	1.856.132.000

	Fastening	Component	Ø	Value(daNm)
-	Connector	RIGID PIPE REAR CYLINDERS (ABS)	M10 x 1	1.6

- 0010T64 brake and or clutch fluid check level and top up as necessary - 0010T65 hydraulic brake system bleed air - 4450B11 WHEEL (one) rear - R.R.Connect the battery negative terminal.

	Name	Connector
-	Battery	A1

Remove the car from the ramps.